What gets fixedMicrowave Repairs the Pros Handle
These cover the over-the-range, built-in wall, drawer and convection combo models that are worth repairing. Each starts with a safe capacitor discharge before any testing.
No heatHums but Does Not Heat
Everything seems to run except the heating. That points to the high-voltage circuit: a failed magnetron, a shorted diode, an open capacitor, or a burnt transformer winding. The pro checks each part with a meter after bleeding the stored charge.
- Magnetron filament and insulation tests
- Diode and capacitor checks
- Transformer primary and secondary readings
SparksArcing and Sparks Inside the Cavity
Blue flashes along the side wall usually come from a greasy or burnt waveguide cover, chipped cavity paint, or a damaged rack support on a convection model. Left alone, arcing can pit the cavity and ruin the magnetron.
- Waveguide cover replacement
- Cavity paint and rack support inspection
- Stirrer and antenna check
Door switchesDead Unit or Runs With the Door Open
The door has several interlock switches and a monitor switch that blows the line fuse if the others fail. A totally dead microwave often means that fuse did its job. If yours runs with the door open, unplug it now and do not use it again until it is checked.
- Primary, secondary and monitor switch tests
- Line fuse replacement with root cause found
- Door latch and hinge alignment
ControlsTouchpad, Control Board and Will Not Stop
Dead buttons, phantom beeps, or a unit that keeps running after the timer ends point to the membrane touchpad or a stuck relay on the control board. The technician reads the keypad circuit with a meter and checks the relays before ordering parts.
- Membrane keypad testing
- Control board relay and power supply checks
- Display and clock faults
OTR ventVent Fan, Filters and Light
Because an OTR unit doubles as the hood over your cooktop, the vent side wears out too. The technician can replace a noisy fan motor, a burnt cooktop lamp, clogged grease filters, and the charcoal filter used on recirculating setups.
- Vent fan motor and damper
- Grease and charcoal filter replacement
- Cooktop light and lamp socket
MountingTurntable, Mounting Plate and Wall Bracket
A plate that will not spin usually needs a turntable motor or a new coupler. OTR units that sag or rattle may have a loose wall bracket or top bolts pulled through the cabinet, which is a safety issue with a hot stove below.
- Turntable motor and coupler
- Mounting plate re-anchoring into studs
- Top cabinet bolt repair